Hello everyone,
We Have a UNIFI 35 combi board, one of our teachers asked me to look at the projector as the bulb keeps turning off every few seconds. Have cleared the vents of dust and debris but every time it is turned on it it displays for about five seconds then stops all the board lights remain lit but we have to turn it off at the wall socket and when turned back on again image goes after 5 seconds there is not even a dim glow from the bulb.
Any ideas / thoughts greatly appreciated
It could need an new lamp or maybe a fan failure? are there any status lights flashing on the projector?
You may find some information here about troubleshooting the unifi 35 projector
Last edited by NDW; 3rd October 2012 at 02:24 PM. Reason: More info added
No flashing lights or anything apart from the lack of image it all appears to be in working order, lamp hasnt done many hours just a bit shy of 1500.
the fans are quiet and can only be heard by standing on a chair and putting ear up close.
possibly a faulty temp sender... or maybe a faulty lamp. either way it'll probably be expensive to repair!
If it's out of warranty i reckon it might be time for a new one!
Sounds like lamp could it have been turned off with out cooling its a sure killer on this model.
Replacement projectors are a no no on this way too expencive even if you can find one.
Marc
Projector Engineer
Oaktech (3rd October 2012)
Why did they only run this model for a short while... we have replaced all of our UniFi's they are great hat stands...
Lamp, we have had the same problem with the same unit, replaced the lamp and working fine now. Lamp hours was only 1500 as well.
Originally Posted by rad
Its because they needed them all for the "war of the worlds" film as the alieans
Marc
Projector Engineer
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
LinkBack URL
About LinkBacks